Robust as it is, drywall can withstand solely limited abuse. Use an electronic stud finder to mark the studs behind the damaged drywall, then use a drywall saw or reciprocating noticed to cut away the drywall. Be sure to follow spraying the feel onto a scrap of drywall or cardboard to high quality-tune your method earlier than you spray it on the wall patch.
Then cowl it with patching compound as you’d for another wall restore. The restore technique for a hole in a wall is determined by the quantity of injury. To restore a reasonably large gap, such because the one proven right here, you’ll need furring strips and a bit of drywall to cowl the realm earlier than you can apply joint compound and finish the wall.
Cover the patch with joint compound. Use a 6-in.-wide putty knife and apply the compound as shown within the two photographs. There are every kind of how to patch doorknob-measurement holes. In case you are changing an electrical box, and the drywall gap is just too large for the new box, you’ll be able to observe these similar directions.
Then there are two methods to repair nail pops: use a screwdriver or hammer to drive the nail again into the studs (picture 1), then bracket every nail head with closely spaced drywall screws (image 2); or, take away the nail and drive a screw as a substitute, along with a second screw nearby, to re-secure the drywall to the stud.
Remember the fact that to get a clean end, it takes repeating the method two or possibly even 3 times, letting it dry and sanding it clean between each step. Apply new joint compound if damage is intensive (Image 2). Be careful that the screws don’t break the paper floor of the drywall.