Learn how to patch a hole in drywall. It’s not obligatory to strengthen the horizontal edges of the alternative drywall. Drywall injury that extends throughout one or more wall studs requires more in depth reinforcement and restore. Cowl the realm fully with the joint compound (Image 5). Let dry. Fill gouges that you simply made within the wall with joint compound.
To restore a bubble, fastidiously lower out the affected space with a utility knife (Picture 2). Discard the drywall and remove all exposed drywall nails or screws. To cut the drywall, you’ll be able to both reduce it with the drywall noticed or use a blade knife to score and snap it, scoring the entrance using the blade knife and a straight edge, then snapping it in two pieces.
Following the pencil mark, minimize out the wall part with a drywall knife (Picture 3). The upper the gloss, the more completely different floor textures seem between the patch and the encircling paint. This is one time when it is helpful to have a hole in the wall. Spread drywall compound over the patch, feathering out the edges.
Reduce away free tape with a utility knife. Though the drywall is rarely in peril of falling off the wall, the bumps are visible and unsightly. Apply the primer with a curler so the texture will match the remainder of the wall. Don’t fret about making drywall cracks alongside the nook worse.
After the compound is dry, sand the realm with superb-grit sandpaper (Picture three). Peel away the tape till you see the underlying drywall (Picture 1). Then fill the outlet with joint compound and look forward to it to harden. You will have to apply two or three coats to fully fill holes, but the thin layers dry rapidly and are easy to apply.